ArchSoft Doors by GTI
Installs a wide variety of doors into walls and trims the wall lines. Many door types, both single and double, are available for installation, such as; 90 deg., 45 deg. 180 deg, bi-parting, swinging, folding, sliding, and revolving. The door type and Door Command is picked from a pull-down menu or from a toolbar. Only three pick points are required to install a door; 1st point establishes the hinge point, the 2nd point along the same wall line shows the side for the door opening, and the 3rd point is piciked on the opposite wall line to establish the wall and door frame thickness. Doors and frames can also be installed in exterior walls where the door frame is set back from the face and with a thickness less than the wall. Two other commands are available; a Flip Door command that can change the swing of a door already installed, and a Remove Door(s) which deletes doors and heals the wall lines.