the first of two objects required to define a 2D fillet or selects
the edge of a 3D solid to round or fillet the edge.
Select second object
or shift-select to apply corner: Use an object selection
method or hold down Shift and select an object to create a sharp
If you select lines, arcs, or polylines, their
lengths adjust to accommodate the fillet arc. You can hold down
Shift while selecting the objects to override the current fillet radius
with a value of 0.
If the selected objects are straight line segments
of a 2D polyline, they can be adjacent or separated by one other segment.
If they are separated by another polyline segment, FILLET deletes
the segment that separates them and replaces it with the fillet.
More than one fillet can exist between arcs
and circles. Select the objects close to where you want the endpoints of
FILLET does not trim circles; the fillet arc
meets the circle smoothly.
you select a 3D solid, you can select multiple edges, but you must
select the edges individually.
fillet radius <current>: Specify a distance or press Enter
an edge or [Chain/Loop/Radius]: Select edge(s), enter c, l, or r
a single edge. You can continue to select single edges until you
you select three or more edges that converge at a vertex to form
the corner of a box, FILLET computes a vertex blend that is part
of a sphere if the three incident fillets have the same radii.
from selection of single edges to selection of sequential tangent
edges, called a chain selection.
a tangential sequence of edges when you select a single edge. For
example, if you select an edge on the top of a 3D solid box, FILLET
also selects the other tangential edges on the top.
to a single-edge selection mode.
Specifies a loop of edges
on the face of a solid. For any edge, there are two possible loops.
After selecting a loop edge, you are prompted to Accept the
current selection, or choose the Next loop.
the radius of the rounded edge.
Inserts fillet arcs at each vertex of a 2D polyline
where two line segments meet.
Select 2D polyline:
If one arc segment separates two line segments
that converge as they approach the arc segment, FILLET removes the
arc segment and replaces it with a fillet arc.